Gimbol dead

[Patrik Olson]

Hello all P2 flyers!

I have some problem with my gimbol H3-3D unit.
It is dead after an update of firmware.

I have tried to re-set the unit by short cutting the connection points as showned in severel videos on youtube.
- I have been very focused on really connect correctly to make the short cut.

Do anyone have a tip on how to get my gimbol back to life?

Most appriciated for any help in this matter.

Regards,
Patrik

 

[kilos1]

i had a problem like that, with the gimbol. when i turn the drone the gimbol did come to life and went to center. but when i moved the gimbol to point down, it went but will not come back up.
after talking to dji, i connect the drone to the computer and went back to the calibrate screen, and that help the problem. so if you did not re-calibrate the gimbol try that.
hope that helped

 

[Patrik Olson]

Thanks kilo1
I will ry to calibrate it and see what happens.

 

[Marlin009]

I had a dead gimbal after an update too. It no longer showed up in the assistant. This is the video I followed to reset it. I used a paper clip. Took two tries.