Update to myself i dint know how to post on this site just yet. My problem with the gps was how close the lid is to the gps plugs into the board. Cut away some insilation but not enough room. Ug help anyonr
hi my friend took too long to respond I know thanks for your help and yes it was the GPS module but I fried a motherboard got another circuit board soon as I turn on the battery same little fire but this time it fried the circuit board I think my flight Rex wires got crossed when I took off the plug to go to the through leg. I have the same thing burn a little note next to the cam buss aux port. I think what happen my top was turned and I took it off to turn it back facing front i rerouted the fly tracks for wire if that shorted out and I did not know that which caused the GPS module to burn out I think. I ordered a new motherboard I'm waiting to do it all over again lol
hi my friend took too long to respond I know thanks for your help and yes it was the GPS module but I fried a motherboard got another circuit board soon as I turn on the battery same little fire but this time it fried the circuit board I think my flight Rex wires got crossed when I took off the plug to go to the through leg. I have the same thing burn a little note next to the cam buss aux port. I think what happen my top was turned and I took it off to turn it back facing front i rerouted the fly tracks for wire if that shorted out and I did not know that which caused the GPS module to burn out I think. I ordered a new motherboard I'm waiting to do it all over again lol
After looking at those photos you'll need a new main board and a GPS module which will run over $200. I assume that aluminum foil was wrapped around the GPS wires. Am i right?
the aluminum foil is for the flytrex it also had a layer of carbon fiber under it. The pic shows the order. I prefer a new board and gps. For now I need the arms to a inspire 1 remote and batt for a new build . Until then I just have to "bebop" around. Lol. Im waiting on a battery for my bebop and I got in patient and ran two words out of the phantom battery strapped it down to the bebop and it worked except for being to heavy in the back.
the aluminum foil is for the flytrex it also had a layer of carbon fiber under it. The pic shows the order. I prefer a new board and gps. For now I need the arms to a inspire 1 remote and batt for a new build . Until then I just have to "bebop" around. Lol. Im waiting on a battery for my bebop and I got in patient and ran two words out of the phantom battery strapped it down to the bebop and it worked except for being to heavy in the back.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.