Got tied up, I’ll get back with the pictures in the morning (Friday).
No image transmission signal - P3P
- Thread starter AsiaFlyer
- Start date
Hopefully these two photos are clear enough for you.
Just to the right of the bt00 pad you can see the copper track from the pad. I have carefully scraped the black coating off to expose it. It is close to the nand chip so a lot of care is involved, along with decent equipment and some soldering skills.
For the bt01 pad, below the pad and slightly to the right is a small resistor. The left end of this resistor is common with the bt01 pad. Care needs to be taken when soldering to these locations. If you have a totally bad board to practice on, it would be helpful.
Good luck to you @mj2019
Just to the right of the bt00 pad you can see the copper track from the pad. I have carefully scraped the black coating off to expose it. It is close to the nand chip so a lot of care is involved, along with decent equipment and some soldering skills.
For the bt01 pad, below the pad and slightly to the right is a small resistor. The left end of this resistor is common with the bt01 pad. Care needs to be taken when soldering to these locations. If you have a totally bad board to practice on, it would be helpful.
Good luck to you @mj2019
That’s why I recommend practicing on a bad board. Having good equipment is highly recommended and pretty much a necessity.
if you mean share sir heres the link click to download
here: https://drive.google.com/file/d/1848C...
- Joined
- Mar 12, 2014
- Messages
- 332
- Reaction score
- 66
NOW THE BIG QUESTION IS HOW TO OVERCOME THE COPY RIGHT PROTECTION??? DURING THE FLASHING PROCESS
?? What copyright protection? Are you talking about a ‘nand write is protected’ message while flashing in serial console?
Do you have light on the front of the gimbal? I see it isn’t showing a sd card inserted, have you put one in to see if it’ll show it?
If it has a blinking green light and shows when a sd card is inserted, then just re-flash the board.?
- Joined
- Mar 12, 2014
- Messages
- 332
- Reaction score
- 66
- Joined
- Mar 12, 2014
- Messages
- 332
- Reaction score
- 66
Check if the cables are connected correctly to the gimbal or if you have any faulty cable or plug.
If the camera has been sitting for quite a while, the P3P gimbal board has a history of loosing the memory in the nand chip. It will need to be re-flashed.
sorry for being unclear, what happened is that some one had an extra gimbal, i wanted to check it for a friend to replace his one crashed physically, so i connected this extra gimbal to a p3p and on app instead of having vid or novideo, look what i got a black screen and dji in middle???!!! what is that and why?
Some of them will say that. I read about why it says that but I don’t remember why. I’ll search for it again and let you know what I find.
Similar threads
