Oof, I'm Stumped

[Jackson216]

I've got a problem with phantom 1,
when I connect a battery to my drone it flashes red, yellow, and green and my drone does not respond to my controller.
I tried using the Naza mv2 assistance, however, i could not connect my drone to the program itself. I made sure to install the driver needed for my PC to recognize the drone, and i followed a couple tutorials on youtube, but I just couldn't figure out the problem

Thought i should mention this all occurred after replacing the motors to the drone.

Thanks,

 

[Jarocha1911]

Sounds like something might not be connected....

 

[BeepBeep]

Hello Jackson, if you are using Windows connect the phantom to a USB 2 port, not a USB 3 port, because, sometimes it works, but sometimes it doesn't work!) I don't know why. Verify also the cable you are using, some cables supplied with chargers, the data signals are not wired. Also check with the Device Manager, that a COM port with the name: "DJI USB Virtual COM (COMx)" is present. If it's not the case, reinstall the DJI Driver. Do not forget to allow the installation of unsigned drivers.