Ok so I have an issue. Bird fires up fine and connects to rc fine with signal and image but it beeps saying main controller data error. And when I check warnings it’s says IMU error as well as barometer error. I calibrate the IMU and still get the error. I check the IMU and get “no calibration needed”. Any one have any advice.
Help
- Thread starter jmcdaniel440
- Start date
Try changing the SD card inside the AC (on the main board) easier to do with the board out of the AC (probably close to impossible to do through the battery compartment).
Have you had a hard landing?
What are your mod values in the sensor tab of the GO app?
Have you had a hard landing?
What are your mod values in the sensor tab of the GO app?
Just changed the internal card. Still getting error. Has had a hard landing in the past but never had this issue until recently. Haven’t flown in a few months
Similar threads
