Drone will not pair with RC.

Joined
May 28, 2016
Messages
99
Reaction score
40
Age
71
Repairing crashed P3P. RC in pairing mode, beeping with blue blinking.
Power on P3P, it's pairing light alternates green and red. Push pairing button and light goes to solid red. Numerous attempts with different timing/ length of button push, always goes to red. No damage can be seen, all antennas, and other connectors are attached. Should I try replacing the circuit board in the sensor housing ? Thanks.
 
Repairing crashed P3P. RC in pairing mode, beeping with blue blinking.
Power on P3P, it's pairing light alternates green and red. Push pairing button and light goes to solid red. Numerous attempts with different timing/ length of button push, always goes to red. No damage can be seen, all antennas, and other connectors are attached. Should I try replacing the circuit board in the sensor housing ? Thanks.

Isnt pairing done via the GO app, under link controller from memory
 
Isnt pairing done via the GO app, under link controller from memory
Normally yes, you would use the app to put the RC into pairing mode and then press the pairing button on the AC for 2 seconds. You can however put the RC into pairing mode manually (without a mobile device / app) by following a certain order of button presses. Then the same, press the AC pairing button for 2 seconds.
 
This isn't a procedural problem. Something is broken. I just replaced the broken landing leg and have ordered a sensor module where the antennas terminate and the pairing button resides.
 

Recent Posts

Members online

Forum statistics

Threads
143,556
Messages
1,471,445
Members
105,550
Latest member
pablosemper