Thanks,
I have yet to open up my P2 to see what the ESC are. The motors do not seem to have any writing on them but again might have when I remove the case. Two of the motors have the black dot rather than the whole black screw fitting for the prop.
Thanks,
I have yet to open up my P2 to see what the ESC are. The motors do not seem to have any writing on them but again might have when I remove the case. Two of the motors have the black dot rather than the whole black screw fitting for the prop.
I have finally opened up my P2 I was wrong about the black mark on the motor. The whole of the top spindle is black not just a dot. (thinking of my old P1). I brought the P2 after the newer motors were released. And the motors do look like the newer ones but no actual markings on them. The ESC are all V2 On checking through various threads on a number of forums I gather that DJI brought out the V2.1 ESC because of issues with the V2 one. And I guess I am now suffering from these issues and had I flown a lot more guess I would have encountered them sooner. Bit annoyed that I now have to pay to have affectively the correct ESC fitted and perhaps new motors as well. Looking at all that soldering I don't feel happy about trying it myself. I have sent DJI an e-mail but don't expect much if any help.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.