I've just tried to update my P3P to V01.11.0020 - it failed. I've successfully updated the firmware before, and followed the notes I used then - formatting SD card prior to start etc.
I tried twice and in both instances, after a couple of minutes of seemingly normal activity (alternating flash red/green light on gimbal, SD card access noise etc) the craft makes a horrible constant screaming sound, the
gimble's LED goes solid red as does the pairing LED, the front LEDs are solid red, rear LEDs are both flashing yellow. This continues for several minutes and only stops when I de-power drone.
Should I just leave it to scream away like that?? Any advice would be much appreciated - I need to fly it on a boys trip in a few days.
In between attempts, I successfully updated the RC controller.
Matthew
NZ
I tried twice and in both instances, after a couple of minutes of seemingly normal activity (alternating flash red/green light on gimbal, SD card access noise etc) the craft makes a horrible constant screaming sound, the
gimble's LED goes solid red as does the pairing LED, the front LEDs are solid red, rear LEDs are both flashing yellow. This continues for several minutes and only stops when I de-power drone.
Should I just leave it to scream away like that?? Any advice would be much appreciated - I need to fly it on a boys trip in a few days.
In between attempts, I successfully updated the RC controller.
Matthew
NZ