Gimbol dead

[Patrik Olson]

Hello all P2 flyers!

I have some problem with my gimbol H3-3D unit.
It is dead after an update of firmware.

I have tried to re-set the unit by short cutting the connection points as showned in severel videos on youtube.
- I have been very focused on really connect correctly to make the short cut.

Do anyone have a tip on how to get my gimbol back to life?

Most appriciated for any help in this matter.

Regards,
Patrik

 

[kilos1]

i had a problem like that, with the gimbol. when i turn the drone the gimbol did come to life and went to center. but when i moved the gimbol to point down, it went but will not come back up.
after talking to dji, i connect the drone to the computer and went back to the calibrate screen, and that help the problem. so if you did not re-calibrate the gimbol try that.
hope that helped

 

[Patrik Olson]

Thanks kilo1
I will ry to calibrate it and see what happens.

 

[Marlin009]

I had a dead gimbal after an update too. It no longer showed up in the assistant. This is the video I followed to reset it. I used a paper clip. Took two tries.

To view this content we will need your consent to set third party cookies.
For more detailed information, see our cookies page.

Accept third party cookies