I have a DJI Phantom 2 with software version 1.08. I have the Zenmuse H3-3D. I have the DJI IOSD mini, and immersion 600MW video transformer. Everything is wired properly as I bought the wiring kit and no soldering plus it worked perfect before. Everything was fine with this firmware version previously. When I power the phantom on with or without the go pro hero 4 black the gamble comes to life. Then it is like it powers off and on. It makes noise, shakes, stutters, loses a little center, goes to center over and over. If I move the x lever on the rear of the controller it goes down but it waits for the "on cycle" This happens about every 2-3 seconds over and over. It does it whether the phantom is on the ground or in the air. The motors on the Zenmuse get pretty warm pretty fast. I recalibrate the compass and the ICU. I checked all of the internal cable connections on the phantom. I have not taken apart the gamble. She flies perfect. I don't know if the video works or not because I need a new receiver(could a bad tx cause this, power issue maybe?). I have had this problem for a long time and I haven't touched it in over a year so I am quite rusty on working on it. Now I want to get her going again for some fpv. I don't remember an event that started the issue. It has had a couple of crashes. I have no Idea what to do. Please let me know what you think.