I've been having the "horizon tilt with Hero 4" issue and someone in another thread with the same issue said a gimbal reset / firmware load fixed theirs.
I attempted the firmware reset as described in the youtube video... the LED goes red/yellow then red for a second, then red/yellow again and stays that way. When I power cycle the LED is indeed green, but the gimbal attempts no startup motion.
In both 3.2 and 3.6 Assistant sotware, there doesn't seem to be any H3-3D detected on the Upgrade tab
Any suggestions?
I attempted the firmware reset as described in the youtube video... the LED goes red/yellow then red for a second, then red/yellow again and stays that way. When I power cycle the LED is indeed green, but the gimbal attempts no startup motion.
In both 3.2 and 3.6 Assistant sotware, there doesn't seem to be any H3-3D detected on the Upgrade tab
Any suggestions?