Hi everyone,
despite some recommendations from other Forums and from DJI themselves not to use the 2.4GHz Datalink groundstation with the P2V+ I installed it. Until today everything was fine, it followed all instructions correctly and always returned back to where it should.
Until today I only used my IPad Mini connected to the ground end via Bluetooth. But today I went a step further and wanted to also control the gimbal/camera by using the regular Vision App via WiFi on my IPhone. So I turned on the WiFi repeater on my Transmitter, connected the IPhone and opened the Vision App. The Connection was very intermittent but somehow I managed to bring the camera from it's initial Position to the most upward Position. I intended to start the Mission on the IPad and control the gimbal inflight on the IPhone.
But the Upload of the waypoints to the air end did not work. The IPad Groundstation APP reported "Upload Failure" every time. After switching off the Wifi repeater and my IPhone Vision APP it worked.
Is there anyone with the same Setup who does not have this Problem ? Maybe it's the way the two antennas of the air end are attached to the P2V+ ?? Who knows ??
Regards,
Kent
despite some recommendations from other Forums and from DJI themselves not to use the 2.4GHz Datalink groundstation with the P2V+ I installed it. Until today everything was fine, it followed all instructions correctly and always returned back to where it should.
Until today I only used my IPad Mini connected to the ground end via Bluetooth. But today I went a step further and wanted to also control the gimbal/camera by using the regular Vision App via WiFi on my IPhone. So I turned on the WiFi repeater on my Transmitter, connected the IPhone and opened the Vision App. The Connection was very intermittent but somehow I managed to bring the camera from it's initial Position to the most upward Position. I intended to start the Mission on the IPad and control the gimbal inflight on the IPhone.
But the Upload of the waypoints to the air end did not work. The IPad Groundstation APP reported "Upload Failure" every time. After switching off the Wifi repeater and my IPhone Vision APP it worked.
Is there anyone with the same Setup who does not have this Problem ? Maybe it's the way the two antennas of the air end are attached to the P2V+ ?? Who knows ??
Regards,
Kent