This afternoon I went out and flew my P3P in some fairly cold temps. It was about 29 degrees F. I followed the usual procedures for cold weather flight. When I took off and was hovering to let things warm up I noticed a pretty solid vibration (the entire p3p).
After a couple of minutes the vibration seemed to settle down and smooth out.
My question is, is this something that is normal in cold weather flights while warming up or could it be something else?
I should also note: upon starting everything up it said IMU error although I had recently calibrated it. This happened on the first attempt of the flight so I aborted and it went away by the time I got it inside to check it out.
Attempted the flight again and same message and then again, it went away once it warmed up.
Also, got a an unknown can't start contact DJI error, 42 I believe it was which also went away after shutting everything down and restarting the process.
Any ideas? Thanks in advance
After a couple of minutes the vibration seemed to settle down and smooth out.
My question is, is this something that is normal in cold weather flights while warming up or could it be something else?
I should also note: upon starting everything up it said IMU error although I had recently calibrated it. This happened on the first attempt of the flight so I aborted and it went away by the time I got it inside to check it out.
Attempted the flight again and same message and then again, it went away once it warmed up.
Also, got a an unknown can't start contact DJI error, 42 I believe it was which also went away after shutting everything down and restarting the process.
Any ideas? Thanks in advance