Crashed my drone and replaced the yaw arm and flat ribbon. The drone will fly, gimbal goes up and down on its own during start up but you can’t see anything from my screen. I have a camera sensor error and a calibrate error. I connected it to the DJI Assistant 2 and was successful in calibrating it but it would not successfully update the software. Any suggestions from here? The ribbon cable was not an OEM part so I thought maybe it was that. I rechecked all the connections. I would hate to go through replacing the ribbon cable and find out it was something else. One thing troubling is although I was told this cable would work with the advanced model, there is a small leg connector that is not being used. There is no place to connect it to. Any help would be appreciated!