While trying to sort problems with the scroll wheel/camera tiltup/dpwn junction not working, I have another issue I was trying to solve as well.
When I first turn the RC on, it has a loud constant alarm, which can be nulled by going into the RC settings and tab the START button for the joystick calibration.
When I carry out the calibration the horizontal % graphic bar doesnt upgrade, the graphics show the full % values for the joysticks in all directions while rotating them.
As the Hz graphic bar doesnt increase, it therefore stops the FINISH icon to become active, there fore the calibration is not complete.
It doesnt stop me operating, just means I need to clear the alarm every time I power up
Any ideas how to resolve this?
Regards Mike
When I first turn the RC on, it has a loud constant alarm, which can be nulled by going into the RC settings and tab the START button for the joystick calibration.
When I carry out the calibration the horizontal % graphic bar doesnt upgrade, the graphics show the full % values for the joysticks in all directions while rotating them.
As the Hz graphic bar doesnt increase, it therefore stops the FINISH icon to become active, there fore the calibration is not complete.
It doesnt stop me operating, just means I need to clear the alarm every time I power up
Any ideas how to resolve this?
Regards Mike