Goodmorning everyone!
I'm new in the forum and I bought a phantom 3 standard with an error: Gimbal Disconnected, after upgrading to 1.8.10 firmware.
The drone is perfect and does everything in its place. Unfortunately in the process of ignition me from the mistakes that I communicated to you before and restarts continuously. Unfortunately it is impossible to even start the downgrade the firmware to the previous because the gimbal does not read it in any way.
Attached photos and videos.
Thank you
Valerio
I'm new in the forum and I bought a phantom 3 standard with an error: Gimbal Disconnected, after upgrading to 1.8.10 firmware.
The drone is perfect and does everything in its place. Unfortunately in the process of ignition me from the mistakes that I communicated to you before and restarts continuously. Unfortunately it is impossible to even start the downgrade the firmware to the previous because the gimbal does not read it in any way.
Attached photos and videos.
Thank you
Valerio
Attachments
Last edited: