I have a P3A with one motor that sounds like it is beeping. When i turn that motor by hand, the volume changes.
I was schooled by Quaddamage:
"Motors and speakers are similar; you can use motor as speaker with some smart driving. This is why ESCs usually announce error states this way.
This seem like a connection problem between ESC and the MC; unfortunately they're connected by board, not by wires - you will probably have to replace the board, unless you're good enough in electronics to locate the issue.
You should now access flight logs; but best would be not by removing the card, just by entering flight logs transfer mode in DJI Go."
That all makes sense to me and I really appreciate any help I can get. I'm unclear why the DJI GO app does not show an esc error? I am ready to purchase a new center/esc/mc board, unless anyone might have another option to try?
I'm not finding the correct information in the flight logs to help me out with this. Any suggestions on software that can read the .dat files?
I was schooled by Quaddamage:
"Motors and speakers are similar; you can use motor as speaker with some smart driving. This is why ESCs usually announce error states this way.
This seem like a connection problem between ESC and the MC; unfortunately they're connected by board, not by wires - you will probably have to replace the board, unless you're good enough in electronics to locate the issue.
You should now access flight logs; but best would be not by removing the card, just by entering flight logs transfer mode in DJI Go."
That all makes sense to me and I really appreciate any help I can get. I'm unclear why the DJI GO app does not show an esc error? I am ready to purchase a new center/esc/mc board, unless anyone might have another option to try?
I'm not finding the correct information in the flight logs to help me out with this. Any suggestions on software that can read the .dat files?
Last edited: