Now I must admit, I made a total newb mistake after I bought the PV2+ -- I installed a GoPro and this aftermarket FPV kit. I had a crash (on my maiden voyage), that damaged the HD-3D mount. I have since re-installed the original PV2+ camera/gimbal setup, I started to have issues with the picture as seen on my phone (using a Samsung Galaxy phone). The images/video freeze on my phone -- and some times they are pixelated (sp). I noticed one of the 8-pin wire was damaged, so I bought the FPV wire kit and replaced all 3 wires going to the camera. My next flight was better, but the issue still persists.
The pictures and video that I take are flawless when I put them on the computer, this is not an issue with the camera, as it has not been through a hard landing of any sort. The issue seems to be the signal between my phone and the camera. I do use the Booster app, and yes, I have the range extender turned on. This issue mainly seems to occur in flight -- if I'm holding the phantom before take-off, the picture is generally spot on. Once the issue starts, it persists the entire flight. Any thoughts?
The pictures and video that I take are flawless when I put them on the computer, this is not an issue with the camera, as it has not been through a hard landing of any sort. The issue seems to be the signal between my phone and the camera. I do use the Booster app, and yes, I have the range extender turned on. This issue mainly seems to occur in flight -- if I'm holding the phantom before take-off, the picture is generally spot on. Once the issue starts, it persists the entire flight. Any thoughts?