Phantom 3 standard gimbal doing the crazy dance. Replaced the flex cable, have checked all connections etc everything snug and right. Have tested the potentiometer by means of a multimeter and am getting the correct readings. Have also ensured camera shaft is correctly installed as well as the yaw arm shaft.
Controller connects to drone for a few seconds then disconnects again. No errors on the software being shown. On the gimbal itself, a red light flashes.
Anyone have any clue as to what else I can try?
Controller connects to drone for a few seconds then disconnects again. No errors on the software being shown. On the gimbal itself, a red light flashes.
Anyone have any clue as to what else I can try?