My camera started having an intermittent issue on my last flight the other day.
Noticed the black wire, that runs from bottom of drone to the camera/gimbal, had more slack in it than usual. Took the anti-drop pins off, un-clipped the flat/ grey wire, then took the cover off from where the black wire enters/exits.
The black wire was not connected to anything. It has a push-type connector, but the "nub" the connector snaps onto, is missing.
How can this be fixed, without boxing the complete drone up and sending it out to be fixed. Can solder be used?? The contact is still there, but not enough left to clip the wire to.
Any suggestions would be greatly appreciated. H.P.
Noticed the black wire, that runs from bottom of drone to the camera/gimbal, had more slack in it than usual. Took the anti-drop pins off, un-clipped the flat/ grey wire, then took the cover off from where the black wire enters/exits.
The black wire was not connected to anything. It has a push-type connector, but the "nub" the connector snaps onto, is missing.
How can this be fixed, without boxing the complete drone up and sending it out to be fixed. Can solder be used?? The contact is still there, but not enough left to clip the wire to.
Any suggestions would be greatly appreciated. H.P.