Hi all,
I havent been here for a while, I even havent flown my plane for a while..
Today, I was preparing for a shooting session tomorow, and I got notice that firmware should be update on both airplane and RC.
First I updated RC fw, via DJI GO app (android), and everything looked fine. Then I switch on the plane, and after connecting to my cell phone, I lost rc connection.
I thought its becose of old plane firmware, and I updated it. I got all OK messages. But thing its not working.
I turn on the remote, I turn on the plane, and I got this:
signal led on rc remains solid red, front lights on the plane are solid red, and rear are blinking yellow.
On my screen I have "Remote Controller Signal Weak" red-alert, and no pic from camera, and when enter the overal status, for Radio Channel qualitiy I have POOR with "strong interference" light ball below. Im in my room, same as ever, and one meter from the plane.
All data from airplane are not available.
Remote fw status is 1.9.2 (which I think is new), I have App ver. status 3.1.8, and none for "version".
So, what should I do? Where to start to address the problem??
thank you
I havent been here for a while, I even havent flown my plane for a while..
Today, I was preparing for a shooting session tomorow, and I got notice that firmware should be update on both airplane and RC.
First I updated RC fw, via DJI GO app (android), and everything looked fine. Then I switch on the plane, and after connecting to my cell phone, I lost rc connection.
I thought its becose of old plane firmware, and I updated it. I got all OK messages. But thing its not working.
I turn on the remote, I turn on the plane, and I got this:
signal led on rc remains solid red, front lights on the plane are solid red, and rear are blinking yellow.
On my screen I have "Remote Controller Signal Weak" red-alert, and no pic from camera, and when enter the overal status, for Radio Channel qualitiy I have POOR with "strong interference" light ball below. Im in my room, same as ever, and one meter from the plane.
All data from airplane are not available.
Remote fw status is 1.9.2 (which I think is new), I have App ver. status 3.1.8, and none for "version".
So, what should I do? Where to start to address the problem??
thank you