Hi folks,
After a crash I ordered a new yaw from ebay. But I am stuck with dismantling the old yaw, at the final spot.
If I can get this loose, I have the old one in my hands. Please help.
Itś the spot where the yaw fits to the bottom of the body. There is a flat cabel running into (I think) the body stepper motor, This cable is running through a small channel which is covered. The cover has two small screws, which I can only access from the bottom side. I cannot reach these.
Can anyone telle me what the next step is? I searched on youtube, but there is only a Tuto for the P3.
Kind regards, Rene
After a crash I ordered a new yaw from ebay. But I am stuck with dismantling the old yaw, at the final spot.
If I can get this loose, I have the old one in my hands. Please help.
Itś the spot where the yaw fits to the bottom of the body. There is a flat cabel running into (I think) the body stepper motor, This cable is running through a small channel which is covered. The cover has two small screws, which I can only access from the bottom side. I cannot reach these.
Can anyone telle me what the next step is? I searched on youtube, but there is only a Tuto for the P3.
Kind regards, Rene