- Joined
- Aug 5, 2020
- Messages
- 4
- Reaction score
- 0
- Age
- 38
Hi all,
I've been looking for solutions for a similar problem all over the internet.
When I power on my drone it connects properly to my remote control and I can see live video feed for a second. Then, the video feed disappears as if the drone were offline or it becomes very pixelated. During that time the camera is looking straight forward but it's not responding to the remote control. The fan spins for 2-3 sec, then stops, then spins again. At some point the fan starts spinning constantly and the camera can be moved by the remote control. However, there is no video feed and the recording button is not working. Sometimes at this point I would also get the "processor is critically overheated" message even though the fan seems to be working properly.
The drone has had a crash in the past but it continued working after that for weeks. My suspicion was also that maybe some sand had entered, thus is opened the bottom part and cleaned the sand I saw which wasn't much but I hoped it would change things. DJI support suggested that I should update the firmware with DJI Assistant 2 which I did successfully, however the issue persists.
Any further suggestions what I shall do to save this drone are highly appreciated.
I've been looking for solutions for a similar problem all over the internet.
When I power on my drone it connects properly to my remote control and I can see live video feed for a second. Then, the video feed disappears as if the drone were offline or it becomes very pixelated. During that time the camera is looking straight forward but it's not responding to the remote control. The fan spins for 2-3 sec, then stops, then spins again. At some point the fan starts spinning constantly and the camera can be moved by the remote control. However, there is no video feed and the recording button is not working. Sometimes at this point I would also get the "processor is critically overheated" message even though the fan seems to be working properly.
The drone has had a crash in the past but it continued working after that for weeks. My suspicion was also that maybe some sand had entered, thus is opened the bottom part and cleaned the sand I saw which wasn't much but I hoped it would change things. DJI support suggested that I should update the firmware with DJI Assistant 2 which I did successfully, however the issue persists.
Any further suggestions what I shall do to save this drone are highly appreciated.