Has any one else had any problems were they could not get there motors to start after updating the firmware and the phantom assistant??
I cant get the motors to start if update to version 3 assistant if I down grade to ver 1.8 they start no problem then if I re-update it back to ver 3 they don't come one for any thing . I tried rebinding the controller even tried updating the controller firmware in the RC assist and recalibrating it Againnnnnnn and it still don't seem to help. Yet no problem if i fall back to v1.8
I also made sure I updated the pc330b to.
So any one know what the trick is to get the motors to spin? after up dating every thing
all I get when I pull the sticks down to the center is my leds turn to red telling me the sticks arent centered when of course they are not of Im holding then down and to the center. and just to be sure my tx as calibrated I just redid it in the RC assistant and in the phantom assistant 3.
I cant get the motors to start if update to version 3 assistant if I down grade to ver 1.8 they start no problem then if I re-update it back to ver 3 they don't come one for any thing . I tried rebinding the controller even tried updating the controller firmware in the RC assist and recalibrating it Againnnnnnn and it still don't seem to help. Yet no problem if i fall back to v1.8
I also made sure I updated the pc330b to.
So any one know what the trick is to get the motors to spin? after up dating every thing
all I get when I pull the sticks down to the center is my leds turn to red telling me the sticks arent centered when of course they are not of Im holding then down and to the center. and just to be sure my tx as calibrated I just redid it in the RC assistant and in the phantom assistant 3.