Hello. Finally the new pcb came. I have mixed feelings of joy and fear of combining a trouble. I do not know firmware uses the card but i know phantom now has 1.7.9.
I would like some advice on how to make the best substitute. I have no problems in welding and electronic part but I would like advice on how to handle different versions of firmware between gimbal, pcb, battery and remote control.
In your opinion, just update the firmware directly to version 1.7.9. Or is it better to check if the new card uses an older version and then try to go back with the debug mode?
This is the ultimate hope to remedy the problem of the 5.8 ghz distance
I would like some advice on how to make the best substitute. I have no problems in welding and electronic part but I would like advice on how to handle different versions of firmware between gimbal, pcb, battery and remote control.
In your opinion, just update the firmware directly to version 1.7.9. Or is it better to check if the new card uses an older version and then try to go back with the debug mode?
This is the ultimate hope to remedy the problem of the 5.8 ghz distance