Hi all, I've had my P3S since they were first released and its been a really good drone. Unfortunately, I had my first crash last week and it was a pretty bad one. I was trying to get the perfect shot on a job site and got too close to a tree. The drone clipped a branch and fell probably 25 feet I would say. Now I'm getting the Weak Controller Signal error. I can still connect to the wifi on the drone and see FPV through the camera but I cant fly it and the latest firmware update fails. I took the top off of it and checked the two antenna connections on top of the motherboard and they are still connected. I traced the two wires down to the legs and I dont see any breaks in the antennas. Any ideas what else i should check? Are there more than just the two antennas that go from the feet to the top of the main board? I work in the electronics repair industry and have extensive soldering experience so I'm not scared to tear into it further just looking for some advice/guidance. Thanks in advance for your help!