My brand new P3P also just fell out of sky from about 50ft.. I'm just going to jump in here cause I'm brand new to this site and this thread matches me almost exactly. Unlike the previous guy mine was under full control with Std.GPS/P-mode setting showing on my tablet/DJI Go App. This was my second flight. My first flight about 10 minutes, alt. 10 ft max. During this flight it appeared to have glitched. That's the best term I can use as I've been in R/C for 30+ years and for a split second it it made an audible noise and violently jerked backwards. I was in forward motion at the time. This happened in a matter of a second then it went back to hover under complete control. probably should have boxed it right back up then and took it back to the store. Hindsight is always 20/20. Second flight <2 min. I was moving about 3ft/sec it made an audible squawk noise and just fell out of the sky. I also must add that new out of the box it required an IMU calibration,which after finding the online tutorial I performed it and an Auto Gimble Calibration too as recommended. Seem to me New Out Of Box it should have been ready to go. Anyway I'm praying DJI will respond to my e-mail positively as I cannot afford to burn $1,000. The base to the camera gimble snapped is the only physical damage noted and busted props. Internally its any ones guess. It did record the entire flight until ground impact. Any response appreciated. I noticed guys talking about accessing flight log from tablet. How do I do this? I've been watching tutorial after tutorial on my drone and there is just so much to this thing other than tutorials, sites like these and youtube I'd be freaking clueless. Impossible I did a CSC as I was flying using right stick only at the time.