Well I got my iOSD and FPV cable today. Woo! I've flown a handful of times so far. I cracked open the case and connected everything to make sure the FPV video and iOSD was working, everything looked good! I disconnected everything in order to start the permanent install, but decided to turn on the Phantom just in case. There was one strange beep, along with the regular startup beeps/flashes and then nothing. There were no LEDs and the Phantom was seemingly unresponsive.
I plugged it in to the computer to see if I could figure it out and I got a "COMPASS-ERR" error about abnormal compass data. I tried flicking the S1 switch a few times to try recalibration, but nothing happened. I disconnected the compass and started up the P2 and I got a solid green LED light so that was a change. Plugged in the compass and it went back to no lights again.
I've tried searching for similar problems like this but I've come up empty. Anyone have any clue what's wrong? This wasn't a crash or anything and there's no peripherals attached to the Phantom either. *sigh*
I plugged it in to the computer to see if I could figure it out and I got a "COMPASS-ERR" error about abnormal compass data. I tried flicking the S1 switch a few times to try recalibration, but nothing happened. I disconnected the compass and started up the P2 and I got a solid green LED light so that was a change. Plugged in the compass and it went back to no lights again.
I've tried searching for similar problems like this but I've come up empty. Anyone have any clue what's wrong? This wasn't a crash or anything and there's no peripherals attached to the Phantom either. *sigh*