New Phantom 2 owner, DJI RC Assistant software needed

[Suprspooky]

Hi folks, I am resurrecting a Phantom 2 (Zenmuze 2D camera mount) and I have it close to test fly state (slow flashing green LEDs, GPS working, Controller paired, motors run and controls respond).

I can't find the RC Assistant software for calibrating the Remote, can anyone point me to the software? I assume I need to do a cal of the Remote. (found Software on this site, yay)

I also can't get Win 10 PC to see the Phantom in Vision Assistant 3.8, Win 10 won't allow the DJI Win driver executable to run/install, any help is appreciated.

I may just try to hover today without calibrating anything, hopefully this isn't a terrible idea?

Thx,

Dave

 

[Suprspooky]

Hi folks, I am resurrecting a Phantom 2 (Zenmuze 2D camera mount) and I have it close to test fly state (slow flashing green LEDs, GPS working, Controller paired, motors run and controls respond).

I can't find the RC Assistant software for calibrating the Remote, can anyone point me to the software? I assume I need to do a cal of the Remote. (found Software on this site, yay)

I also can't get Win 10 PC to see the Phantom in Vision Assistant 3.8, Win 10 won't allow the DJI Win driver executable to run/install, any help is appreciated.

I may just try to hover today without calibrating anything, hopefully this isn't a terrible idea?

Thx,

Dave

Woo Hoo, I loaded the software on a Win 7 laptop and I am able to talk to the transmitter and the Phantom, now I need to learn the basics of getting it to hover.

I think I need to adjust for CG for a larger battery (it fits but it sticks out a little further than the 5200mah batt. (any input from experienced pilots, please chime in)