Hi folks, I am resurrecting a Phantom 2 (Zenmuze 2D camera mount) and I have it close to test fly state (slow flashing green LEDs, GPS working, Controller paired, motors run and controls respond).
I can't find the RC Assistant software for calibrating the Remote, can anyone point me to the software? I assume I need to do a cal of the Remote. (found Software on this site, yay)
I also can't get Win 10 PC to see the Phantom in Vision Assistant 3.8, Win 10 won't allow the DJI Win driver executable to run/install, any help is appreciated.
I may just try to hover today without calibrating anything, hopefully this isn't a terrible idea?
Thx,
Dave
I can't find the RC Assistant software for calibrating the Remote, can anyone point me to the software? I assume I need to do a cal of the Remote. (found Software on this site, yay)
I also can't get Win 10 PC to see the Phantom in Vision Assistant 3.8, Win 10 won't allow the DJI Win driver executable to run/install, any help is appreciated.
I may just try to hover today without calibrating anything, hopefully this isn't a terrible idea?
Thx,
Dave
Last edited:
