Just got my new Phantom 1.1.1 and am going through everything before I go near putting blades on it.
I've hooked it up to a virtual PC on my mac with Assist software 2.20
Upgrade page is:
Maincontroller 5.2.0.3, firmware 4.02
receiver is 1.0.0.18
I uploaded PHANTOM_Default_Configuration_FW4.00.nazam
I did the transmitter calibration. (both sticks up, turn on, etc)
I'm now trying the RC tab of the basic tab.
I have the receiver set to D-bus (it was sitting in PPM when I got there)
click Start and move all the sticks to their corners a few times, R won't go all the way right...
(and there's a dead bit on the left side)
when I click finish, R is a tad to the left of center.
Am I doing something wrong? Do I need to go inside the transmitter and adjust a pot?
I've hooked it up to a virtual PC on my mac with Assist software 2.20
Upgrade page is:
Maincontroller 5.2.0.3, firmware 4.02
receiver is 1.0.0.18
I uploaded PHANTOM_Default_Configuration_FW4.00.nazam
I did the transmitter calibration. (both sticks up, turn on, etc)
I'm now trying the RC tab of the basic tab.
I have the receiver set to D-bus (it was sitting in PPM when I got there)
click Start and move all the sticks to their corners a few times, R won't go all the way right...
(and there's a dead bit on the left side)
when I click finish, R is a tad to the left of center.
Am I doing something wrong? Do I need to go inside the transmitter and adjust a pot?