robinb said:
I looked at the manual but I could not really make head or tail of the description of gain control.
So if you figure that out let me know.
Carl - robin,
That was something I was trying to avoid, so I'm glad someone else tried it out.
So onto the how to (mind you i havent done this yet)
But from what I can understand, this will allow a manual adjustment from the gimbals control unit.
If you look at it, there is a little hole with FN next to it.
Hold it down for 3 seconds and you will enter PAM.
Now, according to the instructions:
If the LED flashes RED quick/slow, you have entered the tilt motor output and gain control adjustment
If the LED is YELLOW off/solid/flashing, the V1 Gain control knob isnt in the middle/is in the middle/under adjusting
If the LED is GREEN off/solid/flashing, the V2 Output power knob isnt in the middle/is in the middle/under adjusting
Thats just the table indicating what represents what.
In the instructions - 7.3 and 7.4 tell you how to exactly get into those specific settings to adjust it.
What I dont understand is if you can do this upside down, without a gopro on it. If not, it might be easier to unscrew the controller and flip it around during the adjustments
edit:
Here is what confuses me though:
"Principle of Roll Motor Output Power and Gain Control Adjusting -
Under the same load status, the roll motor gain should decreaae when you increase the output power while you can increase the roll motor gain when the output power decreased. Therefore you can get more roll motor gain by decreasing the output power while the output power is enough to make the G-2D more stable. However, the G-2D anti shaking ability will decrease either when you decrease the motor power
mind = explodes
ok, I think i got it.
V1 and V2 are both adjustable options per "Tilt" and "Roll"
So we ONLY want to adjust the gains, which is the V1 knob