Matrice 100: MC connection to center board failed, Gimbal cannot receive MC data

[kevin84]

Hi everyone,

I’m having a problem with my DJI Matrice 100 and was hoping someone here might be able to help. This occurred after failed firmware update using DJI assistant 2, the it lost connection and started to beep non stop and show these errors.
Errors:

1. Main Controller connection to Center Board failed
2. Gimbal cannot receive Main Controller data

The Zenmuse Z3 still gives live feed, but it shows: “The firmware on the SD card is identical to or older than the current firmware on the device.”
The drone connects to my PC, but it does not appear in DJI Assistant 2 (v1.2.5 or v1.0.5). It’s also beeping nonstop from the gimbal.

I saw online that N1 Assist or M100Repair.exe might fix this issue. Is there any software available that could resolve it?

I would really appreciate any help or suggestions. Thank you in advance.

 

[DoomMeister]

I would suggest joining and posting this in our MatricePilots forum.

DJI Matrice Drone Forum

DJI Matrice Owners - 100, 200, 300, 600 Series - Discussions, Community and Support

matricepilots.com