One of the antenna wire connection on the circuit pulled out during crash and can not connect cable. Do you think it could e soldered? This is for a Phantom STD 3!
Gimble Circuit Board
- Thread starter JAY G
- Start date
Bottom left corner just to the right of the screw hole is where the connection goes.
Last edited:
This picture is of a circuit board that the maker says fits all Phantom 3 models. Can anyone verify that this is so?
FYI! DJI repaired for $125.00. Now have to wait for return shipping to see the results.
- Joined
- May 6, 2018
- Messages
- 16
- Reaction score
- 5
- Age
- 33
How did you go about having it fixed? I have a p3s that a compass wire came unsoldered from the "connector" piece that clips into the circuit board.. Would really like to have it repaired
- Joined
- May 6, 2018
- Messages
- 16
- Reaction score
- 5
- Age
- 33
I think we are both in the same boat as in tech savvy. I sent the parts in to DJI repair. I was going to attempt soldering myself but got cold feet after reading about there might be more than that connection problem. Turns out It was a good move as there were 2 motor problems that I didn't find initially. I think it maybe back mid week. I can only trust them as I have no tools to test. I have only had it a month or so, got to go through the learning curve. I'll keep you posted!
- Joined
- May 6, 2018
- Messages
- 16
- Reaction score
- 5
- Age
- 33
I also had the thought of soldering the connector but as i have zero experience I decided against... I had a very slight crash but my only solve was to purchase another p3s (luckily I have a well paying job) and i figured I would have another for parts or sell it refurbished but im still searching for repair answers, ill look at sending it in forsure
Similar threads
