Hello everyone,
My p 3 pro's gimbal just went limp yesterday.
It worked perfectly 20 mins beforehand. I accidentally switched it on before placing it on the ground and it just went limp then.
I have tried, a forced firmware re install, IMU and gimbal callibration with no luck.
Remote screen says "Gimbal tilt error".
Never crashed and always treated with tlc.
Any help would be greatly appreciated.
Yes it could be the ribbon cable but why did it happen when it wasn't on the ground.
I feel like I am missing something obvious here.
My p 3 pro's gimbal just went limp yesterday.
It worked perfectly 20 mins beforehand. I accidentally switched it on before placing it on the ground and it just went limp then.
I have tried, a forced firmware re install, IMU and gimbal callibration with no luck.
Remote screen says "Gimbal tilt error".
Never crashed and always treated with tlc.
Any help would be greatly appreciated.
Yes it could be the ribbon cable but why did it happen when it wasn't on the ground.
I feel like I am missing something obvious here.
