Had a flight with my P3S and everything was fine. Didn't do anything crazy, but i was hovering over my pool cover that has about a 1/4 inch of water on it. Didn't dunk it at all, but it had a few drops of water on the drone and gimbal when I landed.
I then put my second battery in for a second flight and the gimbal is going crazy and won't stop going all of the way up and down and side to side. Motors get hot and the gimbal motor overload message comes on. I've seen several messages like this on here, but not a good fix. I did check to make sure everything is aligned and all of the screws are tightened. I made sure the ribbon cable is installed correctly.
Any other ideas out there? I am supposed to take it to Colorado in 2 weeks and I am going to be pretty bummed if It's not working.
I'm thinking it's possible a drop or two of water may have gotten onto a connection? Maybe something else? I was thinking about taking the gimbal apart and putting it back together, but the last thing I want to do is make it worse.
Any help would be appreciated!
I then put my second battery in for a second flight and the gimbal is going crazy and won't stop going all of the way up and down and side to side. Motors get hot and the gimbal motor overload message comes on. I've seen several messages like this on here, but not a good fix. I did check to make sure everything is aligned and all of the screws are tightened. I made sure the ribbon cable is installed correctly.
Any other ideas out there? I am supposed to take it to Colorado in 2 weeks and I am going to be pretty bummed if It's not working.
I'm thinking it's possible a drop or two of water may have gotten onto a connection? Maybe something else? I was thinking about taking the gimbal apart and putting it back together, but the last thing I want to do is make it worse.
Any help would be appreciated!