Flytrex?

[offthefront]

So where is the Flytrex going? With the new sensors going to be tough ....m

 

[allemtura]

We will need to buy a 3D printed leg attachment clip.

 

[msinger]

Or, maybe someone will create a flat carbon fiber mount that wedges in between the sensor and bottom of the Phantom. You could then mount the Flytrex unit directly behind the sensor.

 

[Jetlagged787]

And will my shiny new CAN BUS adaptor bought for my P2V+ fit the P3?

 

[bbfpv]

And will my shiny new CAN BUS adaptor bought for my P2V+ fit the P3?

Slim chance but most likely not.

 

[Jetlagged787]

Slim chance but most likely not.

Sure hope you're wrong there bbfpv. Darned 3G arrived the day the P3 was announced so it's still sitting on my bench looking for a home. It would be nice if someone from DJI or a tester could look at the new bird and let us know likely fixing spots For the 3G Live.

 

[bbfpv]

Sure hope you're wrong there bbfpv. Darned 3G arrived the day the P3 was announced so it's still sitting on my bench looking for a home. It would be nice if someone from DJI or a tester could look at the new bird and let us know likely fixing spots For the 3G Live.

Hope I'm wrong too. I don't know enough about the tech, but I'd imagine a new FC would require a new adapter (assuming the new FC isn't just a derivative of an existing one). Mounting probably on the side until someone machines a mount for between the rear legs I'd imagine.

 

[JR Vaughn]

Sure hope you're wrong there bbfpv. Darned 3G arrived the day the P3 was announced so it's still sitting on my bench looking for a home. It would be nice if someone from DJI or a tester could look at the new bird and let us know likely fixing spots For the 3G Live.

Just purchase the adapter for your particular model, eg. P3P