Hello all,
I'm new to the forum and flying drones. So recently, I purchased a used FC40 with an oversized battery. Long story short, battery popped out the back mid flight, dropped about 200 ft. Good news: drone isn't heavy and took no damage that I could see. Battery was smashed all over the concrete. Got a normal sized battery (aftermarket), plugged it up, lights looked all good, went to take off and it got about 3 feet in the air and would not respond to the controller. In fact I had to lay it down and unplug the battery. Now when I plugged it back in, if gives a few random flashes, then flashed yellow, green, yellow green (several times) which is the normal warming up mode. After that??? No light at all. No blinking, no nothing. However, the drone is still humming and powered on.
ANY ADVICE????
I'm new to the forum and flying drones. So recently, I purchased a used FC40 with an oversized battery. Long story short, battery popped out the back mid flight, dropped about 200 ft. Good news: drone isn't heavy and took no damage that I could see. Battery was smashed all over the concrete. Got a normal sized battery (aftermarket), plugged it up, lights looked all good, went to take off and it got about 3 feet in the air and would not respond to the controller. In fact I had to lay it down and unplug the battery. Now when I plugged it back in, if gives a few random flashes, then flashed yellow, green, yellow green (several times) which is the normal warming up mode. After that??? No light at all. No blinking, no nothing. However, the drone is still humming and powered on.
ANY ADVICE????
