DJI Go Indicator

[Johnny Canuck]

Hello, in the screenshot attached, there is an indicator to the right of the screen.
I can't for the life of me figure out what it's for. I assumed gimbal angle, but the indicator never moves. Also, it never goes to the top. Any thoughts?

I have the latest Go update and all firmware updates.

 

[Multicoptertec]

Gimbal tilt.

 

[Multicoptertec]

Roll the gimbal wheel on your controller, and you will see this indicator move. I think you can also touch that dot in the app, and drag up and down.

 

[Johnny Canuck]

Gimbal tilt.

Ok, as I stated, that was my assumption. Any thoughts as to why it's non-functional and doesn't go to top? Phantom 4, iPad mini 2.

 

[Multicoptertec]

In your screenshot, you are not connected to the bird. Connect, and see how it behaves.

 

[Johnny Canuck]

In your screenshot, you are not connected to the bird. Connect, and see how it behaves.

Yeah, I'm not connected right now, but was yesterday. Will try again. Perhaps recalibrating the gimbal etc will help.

Thanks for the responses.

 

[jaddario19]

If you want it to go to the top, you need to go to gimbal settings, advanced settings and enable upwards gimbal tilt. Limit is 30 degrees

Sent from my SM-G935W8 using PhantomPilots mobile app

 

[Johnny Canuck]

Confirmed that the issue remains. Gimbal wheel does not control up/down, however, I can control it on the screen.
The indicator is still not at the top.
Is there a setting to disable the gimbal wheel that I may have clicked? Can't find it anywhere.

 

[jaddario19]

That sounds like an issue with your remote and not the software. As far as I know there is no setting to disable the gimbal wheel. Can you reach the top when you do it on screen? With upward tilt enabled?

Sent from my SM-G935W8 using PhantomPilots mobile app

 

[Johnny Canuck]

Got it... the Configuration 1, 2, 3 settings were all different. I didn't see that before. I assume these are presets that you can switch between, but can't find documentation on that. The issue was the Gimbal Tilt EXP setting set to 0 in one of the configurations. I set it to 100 and that resolved it.
For now, I have all three set the same and all appears good again. I did get the upwards tilt working, then disabled it.

Thanks again for responding.