Phantom 3 advanced
Having failed a previous firmware update, the main gimbal board appeared to be dead and was replaced. When the firmware update was attempted, this time the board burned out and the yaw motor also. The update process did seem to take rather a long time with the motors twitching around most of the time.. The sd card showed that the update had been successful. The flexi to the yaw was burned and also a couple of components on the main gimbal board. So the next proposal is to replace the main board and the Yaw motor but disconnect the gimbal motors before attempting to install the firmware, thus taking the pressure off the gimbal motors.
Has anyone tried this before ?
Does anyone know if this procedure is feasible ? Is it likely to work ?
I shall value any assistance.
Having failed a previous firmware update, the main gimbal board appeared to be dead and was replaced. When the firmware update was attempted, this time the board burned out and the yaw motor also. The update process did seem to take rather a long time with the motors twitching around most of the time.. The sd card showed that the update had been successful. The flexi to the yaw was burned and also a couple of components on the main gimbal board. So the next proposal is to replace the main board and the Yaw motor but disconnect the gimbal motors before attempting to install the firmware, thus taking the pressure off the gimbal motors.
Has anyone tried this before ?
Does anyone know if this procedure is feasible ? Is it likely to work ?
I shall value any assistance.