- Joined
- Aug 10, 2013
- Messages
- 21
- Reaction score
- 11
Hello,
I have some problems with my phantom. The compass always had issues and the Mod Value was always around 650.
I upgraded the firmware to 3.16 and when I went outside I got after warmup the 2 yellow flashes (and they do not go away).
So I ordered a new compass one and replaced the old one.
Again the 2 yellow flashes.
Then I downgraded to 3.14 and did n Advanced and a Basic calibration.
Suddenly I could calibrate the compass and everything worked.
Now when downgrading it went from an X to a + model - so it did not fly.
I changed it and recalibrated it.
Inside it it showed me everything OK (even without calibration) but could not find the satellite
When I turned it off, went outside and turned it on again I only got again the 2 yellow flashes.
I have not found any information on these 2 yellow flashes.
And the compass values are still 000 0
Does anyone know what is the problem?
Thanks!
Regards
Bernd
I have some problems with my phantom. The compass always had issues and the Mod Value was always around 650.
I upgraded the firmware to 3.16 and when I went outside I got after warmup the 2 yellow flashes (and they do not go away).
So I ordered a new compass one and replaced the old one.
Again the 2 yellow flashes.
Then I downgraded to 3.14 and did n Advanced and a Basic calibration.
Suddenly I could calibrate the compass and everything worked.
Now when downgrading it went from an X to a + model - so it did not fly.
I changed it and recalibrated it.
Inside it it showed me everything OK (even without calibration) but could not find the satellite
When I turned it off, went outside and turned it on again I only got again the 2 yellow flashes.
I have not found any information on these 2 yellow flashes.
And the compass values are still 000 0
Does anyone know what is the problem?
Thanks!
Regards
Bernd