What do I look at next???

[granitelvr]

I replaced the flexible gimbal cable, adjusted the gimbal motor. The camera still can’t get level and still getting a gimbal overload warning. Where do I go from here!?!?!???

 

[dirkclod]

You have tried Calibrating the camera right ?

 

[granitelvr]

You have tried Calibrating the camera right ?

Is that the IMU calibration?

 

[dirkclod]

No it’s called Auo Gimbal Cal. My bad

 

[granitelvr]

Tried that and an IMU calibration and no luck. I have a video of the symptoms. But can’t figure out how to add it to this post.

 

[dirkclod]

Well you would have to put it on YT or Vimeo and what I suggested was just a shot in the dark. Hopefully someone will chime in with more suggestions and good luck.
Welcome to the forum by the way .

 

[granitelvr]

Well you would have to put it on YT or Vimeo and what I suggested was just a shot in the dark. Hopefully someone will chime in with more suggestions and good luck.
Welcome to the forum by the way .View attachment 102130

Thanks! I think I may have to sell for parts and cut my losses.

 

[ArmyVet]

Not an expert, but why did you need to replace the cable?
Might be a clue in there....

 

[ArmyVet]

Not an expert, but why did you need to replace the cable?
Might be a clue in there....

Was there a crash initially??