Ok it's finally my turn of needing some help as I'm truly stumped and have yet to figure it out. So....who better to turn to then you.
I had my quad drop out of the sky 3 weeks ago and I have slowly been putting it back together.
I had to replace the complete body, 1 motor and esc. I also had replaced the camera and gimbal with a new one.
Currently the gimbal is not working but I almost sure it is from a couple reversed wires that I will switch after posting this thread. Before installing a new camera and gimbal the old one was going from side to side with the camera and not up & down like it should. Be adding the new replacement I switched the wires thinking that was the reason for the side to side movement. But it ended up not allowing the camera to move at all.
But here is one of the main concerns. Since the 1st time of powering the quad, inside the gimbal has a alarm going off. It beeps two times back to back, over & over.
With everything activate and motors running, it has video, takes a pic. Gimbal has been limp, only telemetry out everything that appears on screen is range extender, pic number, wifi bars, and sd card. Nothing else. No battery, no satellites, no speed, no distance, or any other telemetry.
I have connect the quad to the assistant and ran advanced ecu as well as loaded the most recent firmware.
What is wrong?
The gimbal and alarm has me confused, outside of that Im leaning toward the Naza?
Thanks to anyone that helps me figure this out. Hopefully someone who experienced this problem will know what to do.
-Frank
I had my quad drop out of the sky 3 weeks ago and I have slowly been putting it back together.
I had to replace the complete body, 1 motor and esc. I also had replaced the camera and gimbal with a new one.
Currently the gimbal is not working but I almost sure it is from a couple reversed wires that I will switch after posting this thread. Before installing a new camera and gimbal the old one was going from side to side with the camera and not up & down like it should. Be adding the new replacement I switched the wires thinking that was the reason for the side to side movement. But it ended up not allowing the camera to move at all.
But here is one of the main concerns. Since the 1st time of powering the quad, inside the gimbal has a alarm going off. It beeps two times back to back, over & over.
With everything activate and motors running, it has video, takes a pic. Gimbal has been limp, only telemetry out everything that appears on screen is range extender, pic number, wifi bars, and sd card. Nothing else. No battery, no satellites, no speed, no distance, or any other telemetry.
I have connect the quad to the assistant and ran advanced ecu as well as loaded the most recent firmware.
What is wrong?
The gimbal and alarm has me confused, outside of that Im leaning toward the Naza?
Thanks to anyone that helps me figure this out. Hopefully someone who experienced this problem will know what to do.
-Frank