There are plenty of gimble dance threads but not quite like mine that I found.
Thanks for that verification, mine was off. It is now aligned like your photos. The allen head set screw on the shaft was a bit lose, now tightened. But I still have a slight tick when the body tilts to the right, no other angle. It stops when leveled. Anything else come to mind that might do that I can check. Learning curve verticle at this time, all good. Thanks
If it still has a slight tick while banking it, the pitch motor shaft may be slightly off center still. That shaft with the flat surface, rotates the potentiometer on that small circuit board. If it’s not perfectly centered it will work well in one direction but not the other. Not enough resistance in the circuit that one way.Thanks for that verification, mine was off. It is now aligned like your photos. The allen head set screw on the shaft was a bit lose, now tightened. But I still have a slight tick when the body tilts to the right, no other angle. It stops when leveled. Anything else come to mind that might do that I can check. Learning curve verticle at this time, all good. Thanks
We use essential cookies to make this site work, and optional cookies to enhance your experience.