After reading some posts here I caught myself taking a time out when flying today to see about this shake or the lack thereof.
I had it hovering at about 5 feet above the ground today and took a good hard look to see if there was any shake in the gimbal and low and beyond there it was! Not very much shaking and very slight but quite noticeable and fairly constant either when I was hovering, ascending or descending.
Million dollar question is : is this standard/normal or are there folks out there that have absolutely no shaking whatsoever when flying ??
Perhaps it was always there and I just didnt take notice so any feed back would be great !
note : up to date firmware already installed , props perfectly balanced , IMU and gimbal calibration just done when uploaded the new firmware last week,never crashed and no wind when flying BUT no noticeable vibration in 4k Video when played back ( like I said- slight shaking ) BUT if this is not norma i would like to fix as it could eventually lead to shell cracking ....thank you for your replies !
I had it hovering at about 5 feet above the ground today and took a good hard look to see if there was any shake in the gimbal and low and beyond there it was! Not very much shaking and very slight but quite noticeable and fairly constant either when I was hovering, ascending or descending.
Million dollar question is : is this standard/normal or are there folks out there that have absolutely no shaking whatsoever when flying ??
Perhaps it was always there and I just didnt take notice so any feed back would be great !
note : up to date firmware already installed , props perfectly balanced , IMU and gimbal calibration just done when uploaded the new firmware last week,never crashed and no wind when flying BUT no noticeable vibration in 4k Video when played back ( like I said- slight shaking ) BUT if this is not norma i would like to fix as it could eventually lead to shell cracking ....thank you for your replies !