Hi guys [& gals]
Has anyone had experience of fitting reinforcement plates to the arms of the P3? I have just had to have the shell replaced because of stress cracks, which I believe are an unwanted free extra with the P3! There are some old posts about these reinforcement plates, but the company no longer exists. I've found some in alloy on Amazon, but the instructions say you have to remove the existing screws which hold the motor & replace them with supplied longer screws [obviously] . I'm not particularly good with my paws, & I'm wondering whether that's as easy as it sounds, since during the process, the motors will no longer be screwed to the shell. Any tips, warnings, caveats, instructions welcome.
Thanks
Has anyone had experience of fitting reinforcement plates to the arms of the P3? I have just had to have the shell replaced because of stress cracks, which I believe are an unwanted free extra with the P3! There are some old posts about these reinforcement plates, but the company no longer exists. I've found some in alloy on Amazon, but the instructions say you have to remove the existing screws which hold the motor & replace them with supplied longer screws [obviously] . I'm not particularly good with my paws, & I'm wondering whether that's as easy as it sounds, since during the process, the motors will no longer be screwed to the shell. Any tips, warnings, caveats, instructions welcome.
Thanks