Before flight I go to the pilot App and set the RTH Altitude to 30m. (Advanced-Failsafe) I then go to set home point and a message comes up saying it will return to this point at a min altitude of 0.0. I wasn't sure if this was an error so I tested and the Phantom 3 and after take off, flew to about 10 meters and about 40 feet away and pressed RTH. the P3P immediately started to descend to 0 ft. Hard landing but ok.
P3P was all in green and flies fine, but I have never been able to get the RTH altitude to work
P3P firmware 1.2.6, latest iOS app
P3P was all in green and flies fine, but I have never been able to get the RTH altitude to work
P3P firmware 1.2.6, latest iOS app