Re: After install of Rotorpixel "Connection to Phantom Faile
While powerd OFF recheck the servo power cable and listen for defined click when fully plugged in. Also, check your camera power switch should be All the way right to "Wifi On"...also, You didnt by chance hit the" bind" button did you?
Additionally, there have been instances where people plugged in the power cables while the phantom is powered on.. This is covered in the installation manual. A definate NO NO, and has resulted in dead cameras.
Good luck. Hope this helps.
While powerd OFF recheck the servo power cable and listen for defined click when fully plugged in. Also, check your camera power switch should be All the way right to "Wifi On"...also, You didnt by chance hit the" bind" button did you?
Additionally, there have been instances where people plugged in the power cables while the phantom is powered on.. This is covered in the installation manual. A definate NO NO, and has resulted in dead cameras.
Good luck. Hope this helps.