Reinforcement plates installation

[George J Zanatta]

Does anyone know the size of tip you need to remove the body screws to install the reinforcement plates? The screws holding the motors no problem! but the other once are giving me a headache

 

[Oso]

Does anyone know the size of tip you need to remove the body screws to install the reinforcement plates? The screws holding the motors no problem! but the other once are giving me a headache

Maybe this from the UAV web site will help...

What you get:
4 reinforcement plates
8 M2.5 screws
16 M3 screws

What you will need:
2mm hex driver
1.5mm hex driver
T8 torx driver to remove factory screws in phantom shell

 

[George J Zanatta]

Maybe this from the UAV web site will help...

What you get:
4 reinforcement plates
8 M2.5 screws
16 M3 screws

What you will need:
2mm hex driver
1.5mm hex driver
T8 torx driver to remove factory screws in phantom shell

THANKS! The T8 torx is what I am missing! Quick run to Harbor tools and is done