Phantom 3pro not receiving video

[Sppencer1190r]

Greetings I am in need of some serious help. I have phantom 3 pro that not receive and video transmission. I have tried updating firmware, different USB cables just about everything. What it will do is allow me from the controller move the camera around but not start the engine.
If any of you have ideas please please share them. If you need more info I will also provide that.
Thank You

 

[LarBear360]

Is your software on your devivce up to date? Any chance you can test your connection using a different device?

 

[Sppencer1190r]

Is your software on your devivce up to date? Any chance you can test your connection using a different device?

So software is up to date. I do not have another device. I did purchase a new board for the back of the controller thinking it could be worn out at the USB plug in.
Question as a last resort if I buy a controller can I bind it with the drone? This my last resort. Any more thoughts and thank you for replying

 

[KachemakDiver]

So software is up to date. I do not have another device. I did purchase a new board for the back of the controller thinking it could be worn out at the USB plug in.
Question as a last resort if I buy a controller can I bind it with the drone? This my last resort. Any more thoughts and thank you for replying

Is the app connecting to the device? Does it say disconnected on the device screen?

 

[LarBear360]

I had issue just today with my P3P. The controller was linked and I could take off and fly. The app would not connect. I thought it was the cable but then again I've used that cable before. After several power up/power down, it finally connected. Not really sure what, if anything, I did differently. I recall reading about a specific start sequence but never really thought it mattered as it always worked.

To answer your question, yes, A new controller can be linked.

 

[Sppencer1190r]

Is the app connecting to the device? Does it say disconnected on the device screen?

Yes it says disconnected

 

[KachemakDiver]

L

Yes it says disconnected

Ok, is the light on the remote controller green? And also the little LED light on the side of the VPS/OFDM should be green also.

 

[KachemakDiver]

I recall reading about a specific start sequence

You are correct, if everything is working properly the sequence of powering up does not matter.

 

[Sppencer1190r]

L

Ok, is the light on the remote controller green? And also the little LED light on the side of the VPS/OFDM should be green also.

They both are red and sometimes the controller beeps constantly

 

[KachemakDiver]

I am assuming that you have tried doing the linking process?

 

[Sppencer1190r]

I am assuming that you have tried doing the linking process?

Let me try that again to be on the safe side and not wasting your time.

 

[KachemakDiver]

I understand the camera is responsive. Can you start the motors?

I believe the OP said the motors won’t start.

 

[psl_air]

Just out of curiosity what device are you using? Was it working and then suddenly lost connection? I would imagine the more info you post the better the odds are someone may be able to help.

 

[LarBear360]

I believe the OP said the motors won’t start.

Yup, he sure did. I deleted the post.

 

[KachemakDiver]

@Sppencer1190r, have you any success on this issue? Please let us know.

 

[Sppencer1190r]

I believe the OP said the motors won’t start.

That's correct the motor will not start but I can move the camera around. I am going to try and bind it like you said tonight. Thanks!

 

[KachemakDiver]

That's correct the motor will not start but I can move the camera around. I am going to try and bind it like you said tonight. Thanks!

??